Akuvox General || A092S A/C Power Wiring Instructions

Akuvox General || A092S A/C Power Wiring Instructions

A092S A/C Power Wiring Instructions

 

Note: A092/ A094 uses A/C Alternating Current with 110/120vac for power. A power cable is not provided and will need to be made or using Romex to run back to the building circuit panel or junction box.

 

  1. Locate the AC Breaker inside the A09x and make sure it is switched OFF (down position).

  2. Insert your 3 prong stripped cable through one of the knockouts in the panel.

  3. Make note of your 3 prong plug cable pinout.

  4. Connect your 3 prong cable “Ground” wire to the A09x chassis using one of the supplied screws and ground locations as seen in the below image example 1.



Example 1

 

  1. Next connect the 3 prong “Neutral” wire to the A09x Circuit Breaker leading to the Converter Terminal labeled “N” as seen in example 1 and 2

Example 2

 

  1. Next connect the 3 prong “Load/ Live” wire to the A09x Circuit Breaker leading to the Converter Terminal labeled “L” as seen in example 1 and 2

  2. Make sure all connections are correct and secured then plug in the 3 prong plug to an outlet and switch on the Circuit Breaker in the A092s.

  3. The A09x will power on with LED’s indicating power.

 

Reference images below:

    • Related Articles

    • Akuvox General || How to install Akuvox SR01 to control Electronic Locks || Install

      How to install Akuvox SR01 to control Electronic Locks SR01 is a small accessory that improves the security of doors controlled by Akuvox’s door phones. It ensures that the door remains securely locked, even if the door phone is dismounted or ...

    • Akuvox Local || Akuvox Door Lock Wiring Diagram

      Akuvox Door Lock Wiring Diagram Note: 1. Akuvox integrates circuit protection onto the main board, so you can directly connect Door Strike to Akuvox door phone. 2. When installing a Akuvox door phone at a building without an access control system, ...

    • Akuvox General || Maglock & Exit Button Wiring

      Maglock & Exit Button Wiring Using R20K model as an example: Log in to the web interface of the device’s IP address from a web browser. Note: To find the IP address of your device, your computer must be connected to the same network. It is ...

    • Akuvox General || Maglock & Exit Button Wiring for A02S

      Maglock & Exit Button to A02S Wiring Diagram Maglock Wiring: Connect the Positive wire from Maglock to the RELAY_NC port. Connect the Positive wire from Power Supply to the RELAY_COM port. Connect both Negative wires together from Maglock & Power ...

    • Akuvox General || Standard Electrified Strike Wiring Diagram

      Standard Electrified Strike Wiring Diagram A02/A03 Model relays will be labeled: “RELAY_COM” (Common) “RELAY_NC” (Normally Closed) “RELAY_NO” (Normally Open) Connect the Ground wires together from the Strike & Power Supply using a Wire-nut or B-cap ...