Control4 - Akuvox Communication Settings

1. Call group

Go to Agents interface and add Communication agent first.

The default All call group is only with Control4 devices, like T3.

Users can add new call group, like Call_to_C313_and_T3, and add C313 and T3 to it.

Go to System Design interface to select door phone.

Go to Properties interface to select which group the door phone should call.

Figure 2.8-1 Communication settings

Figure 2.8-2 Communication settings

2. Call volume settings from composer

Go to System Design interface to select the door phone - Intercom, and then users can configure call volume settings.

Note: The call volume cannot be muted from composer.

After each setting is done, upload this project to Controller (File/ Refresh Navigators).

Figure 2.8-3 Communication settings

Figure 2.8-4 Communication settings

NOTE:

Limitation in Akuvox Drivers

1. Supported features from Composer:

SIP settings, unlock via HTTP command settings, video preview settings, Call group (The default All call group is only with Control4 devices, like T3), Ringer, Speaker, Mic sliders (The call volume cannot be muted from composer), Custom Buttons, Alternate Camera

2. Unsupported features from Composer:

Play Door Chime, Do Not Disturb, Auto Answer, Send Video, Stop Video, Pause/Resume Call, Monitor Mode, Current Session, API Calls, set show main/mirror video