Akuvox General || Control4 - Akuvox Lock Control
Control4 - Akuvox Lock Control
Go to Items - My Drivers interface to find the door lock driver.
Double click to add drivers to the project and rename them.
Go to Connections - Control/AV interface and select door lock.
Go to Control & Audio Video Connections interface bind the driver to the device's relay port via directly moving the item to the Relay Output Devices interface.
Figure 2.7-1 Lock manipulation
Go to Programming interface, select the door phone and select door phone event to be UI Button One/Two Pressed.
Go to Actions interface, select door lock, select the lock actions to be Toggle the room->Lock and move the lock action to Script interface.
Go to System Design interface to select the door phone - Intercom.
Figure 2.7-2 Lock manipulation
Go to Properties - Custom Buttons interface to tick to enable two UI buttons which can be used as the trigger for sending HTTP command to door phone to unlock doors and rename them.
Figure 2.7-3 Lock manipulation
Figure 2.7-4 Lock manipulation
NOTE:
Limitation in Akuvox Drivers
1. Supported features from Composer:
SIP settings, unlock via HTTP command settings, video preview settings, Call group (The default All call group is only with Control4 devices, like T3), Ringer, Speaker, Mic sliders (The call volume cannot be muted from composer), Custom Buttons, Alternate Camera
2. Unsupported features from Composer:
Play Door Chime, Do Not Disturb, Auto Answer, Send Video, Stop Video, Pause/Resume Call, Monitor Mode, Current Session, API Calls, set show main/mirror video
Related Articles
Akuvox Local || A092S Electronic Lock wiring with Fire Alarm
A092S Electronic Door Lock wiring with Fire Alarm These are instructions on how to wire in electronic locks with a Fire Alarm Trigger to provide an Unlock to all doors when there is an Active Fire Alarm. We will utilize the A092S included General ...Akuvox General || How to install Akuvox SR01 to control Electronic Locks || Install
How to install Akuvox SR01 to control Electronic Locks SR01 is a small accessory that improves the security of doors controlled by Akuvox’s door phones. It ensures that the door remains securely locked, even if the door phone is dismounted or ...Akuvox General || How to install a Diode on a Door Strike || Installation
How to install a Diode on a Door Strike: The majority of Door Strikes will require a diode to be installed when used with an Access Controller. This prevents electrical kickback and damage to your electronic Access Control Terminal. The diode will ...Akuvox Local || Akuvox Door Lock Wiring Diagram
Akuvox Door Lock Wiring Diagram Note: 1. Akuvox integrates circuit protection onto the main board, so you can directly connect Door Strike to Akuvox door phone. 2. When installing a Akuvox door phone at a building without an access control system, ...Akuvox General || Akuvox - Door Lock does not work when triggered from Indoor Monitor
Akuvox - Door Lock does not work when triggered from Indoor Monitor. Below are troubleshooting questions and steps causing an Akuvox monitor from not opening the door lock. Questions to ask call: Has this worked previously? Was there any work ...