Akuvox Local || How to Trigger Device Relay via HTTP to Open a Door

• Related Articles

• Akuvox Local || How to Configure HTTP Door Unlock

  How to Configure HTTP Door Unlock The EC33 Elevator Controller supports remote door unlocking via an HTTP command. Simply enable this feature and input the HTTP command (URL) for the door phone. This will trigger the relay and open the door, even if ...

• Akuvox Local || Remotely unlock doors connected to C315 Indoor Monitor

  How to remotely unlock Electronic Door Lock that is directly connected to the C315W Indoor monitor relay using HTTP Unlock and Action URL. NOTE: 'remote control enable' means that we can control the local relay remotely. 1. Go to C315 web portal ...

• Akuvox Local || How to Open the Door via DTMF

  How to Open the Door via DTMF DTMF feature allows users to open doors by tapping the DTMF-related Unlock button or entering the DTMF code on the indoor monitor’s keypad during a call. All Akuvox intercom devices support the door opening via DTMF. In ...

• Akuvox Local || How to Configure Web Relay On Akuvox Door Phones

  Scenario Web Relay is a network-based relay that is connected to the door lock for access control. As it is network-based, web relay gives you greater security for access control. This article teaches you how to configure web relay and web relay ...

• Akuvox Cloud || How to configure Web Relay to operate door phones from Indoor Monitors

  Tips: IT83X,C317 has NO/NC/COM three terminals which supports to connect locks by itself. Users can press the Unlock key during the call. . 1. Local Relay Go to Phone - Relay to setup the DTMF code of local relay in website. Relay Type: There are two ...