Titanium General || How to Pair a Doorbell with the ED-DB2-CHIME ||

Titanium General || How to Pair a Doorbell with the ED-DB2-CHIME ||

How to Pair a Doorbell with the ED-DB2-CHIME

Applies to: ED-DB2-CHIME

Question

How do I pair a doorbell with the ED-DB2-CHIME chime?

Answer

Put the chime into pairing mode with its Set button, then press and hold the doorbell’s Bell button so it sends its pairing information to the chime.

Steps

  1. On the chime, press and hold the Set button for 3 seconds. A notification tone sounds and the light flashes. The chime is now in pairing mode.

    Note: Entering pairing mode resets the chime’s previous pairing settings.

  2. On the doorbell, press and hold the Bell button for 5 seconds. The doorbell sends its pairing information to the chime.
  3. When pairing succeeds, a notification tone sounds and the chime’s indicator turns on for 5 seconds, then turns off.


If the chime isn’t paired with a doorbell within 30 seconds, it exits pairing mode and waits for the next pairing attempt. Repeat step 1 to try again.

Verification

Press the doorbell button. The paired chime sounds.

Pairing Rules and Range

ItemDetails
One doorbell to many chimesA single doorbell can pair with multiple chimes, with no limit. When the doorbell is pressed, every paired chime sounds.
One chime to many doorbellsA single chime can pair with only one doorbell.
Signal rangeUp to 100 meters in an open, interference-free area. Wall penetration: 2 walls or fewer.

Multiple entrances: If a property (for example, a villa) has several entrances, install a separate chime at each location and pair each one with the doorbell.

https://drive.google.com/drive/folders/1u2QfIYX_xwIub5eGEaD2OsFbmpLslZ1u