Diamond IPC || How to Set Alarm Input (WEB 3.0) ||

Diamond IPC || How to Set Alarm Input (WEB 3.0) ||

How to Set Alarm Input (WEB 3.0)

 

This knowledge base article provides a step-by-step guide on setting up the alarm input for devices using the WEB 3.0 firmware. This setup ensures that alarms are properly configured and linked to the system, allowing for effective monitoring and response to events.

Setting up the alarm input is crucial for enabling the device to respond to specific events, such as security breaches or other incidents. Proper configuration allows for timely notifications and actions, enhancing the overall security and efficiency of the monitoring system.


Steps to Set Alarm Input

Step 1: Login to your device.
image.png


Step 2: Navigate to Setting > Event > Alarm and enable the alarm.
image.png


Step 3: Select the Relay-in port and set the Anti-Dither time.

  • Anti-Dither: This setting ensures the alarm is triggered only once within the specified time to avoid multiple triggers for the same event.
Step 4: Select the Sensor Type. NO (Never Open) or NC (Never Closed)

image.png


Step 5: Enable the Event Linkage to associate the alarm with specific events.
Step 6: Click Save to apply the settings. Use the Default option to restore all settings if needed.
image.png


Additional Support

For further assistance or inquiries, please contact our tech support at:

Email: support@enssecurity.com
Phone: (888) 397-1999