Emerald IPC || Change IPC from Line to Mic

Emerald IPC || Change IPC from Line to Mic

Change IPC from line to mic

* Note camera needs to have 2-way functionality. You may also use the Access button while on the same network as the recorder. If not, you must use the IP address of the IP camera.

1. Type IP address for camera on URL.

2. Enter username and password.

3. Click the Configuration Tab on top once you are logged in.

4. Click Video/audio on left side panel

5. Go to the Audio tab on the top sub panel.

6. Once you are in the Audio tab. You are able to select between MicIn/LineIn on the Audio Input option.



    • Related Articles

    • Diamond IPC || Changing from Line to Mic || Web GUI

      In some situations will need to switch IP cameras from Line (camera receives audio from the external audio jack) or Mic (camera receives audio from the built in Microphone). Not all models support built in microphones. Check your product model's spec ...

    • Emerald General || Emerald Plug n Play Interaction

      Emerald IPC and UNV NVR Emerald IPC support “Plug and Play” with UNV NVR, the default protocol is ONVIF, basic video functions will be no problem, only intelligent functions are affected. If a customer needs to use intelligent functions, then they ...

    • Emerald Recorder || Line Crossing Setup || Web GUI

      To access the web client, please use a Windows based PC and use Internet Explorer as the web browser. Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: ...

    • Emerald Recorder || Line Crossing Configuration || Local GUI

      1. In the NVR menu, select VCA 2.In the VCA menu, ensure you are on the VCA config tab located on the left and then select the camera that is needed for line crossing setup. Under smart intrusion prevention enable Cross line Detection and select the ...

    • Titanium Recorder || Add Emerald IPC to Titanium NVR || WEB GUI

      Emerald IPC cameras come with ONVIF enabled by default. 1- Identify the camera on the network using ENSTools, login and configure a static IP address. 2-Login on the 3rt party brand in this case is a Titanium NVR, add camera and use the manual ...