Emerald IPC || How to configure Snapshot

Emerald IPC || How to configure Snapshot

  1. Log onto the web interface




  1. To configure a snapshot, under setup go to events on the left hand side and the camera image should come up. Detection mode is set to area on this camera so that means whatever comes into that specific area the camera will take a snapshot of it 


  1. To send the picture to the camera SD card under trigger actions on that same page on the right the image edge storage box is ticked off and that simply sends it all to the SD card. You can set it to send to an email to save space on the SD card as well. 


    • Related Articles

    • Emerald IPC || How to view snapshots from IP Camera

      Log into the web interface Under the photo option on the top of the page it will take you to where the snapshots are stored on the camera. In this screenshot the camera was set to take snapshots whenever motion is detected. Navigate to the proper ...

    • UNV IPC || How to configure Snapshot

      Note: This function or management page may vary with models. Please see the actual Web interface for details. Note: Only some certain models support third stream. To access the web client, please use a Windows based PC and use Internet Explorer as ...

    • Diamond IPC || How to Set Snapshot Function (WEB 5.0) ||

      How to Set Snapshot Function (WEB 5.0) This article provides a step-by-step guide for configuring the snapshot function on devices using the WEB 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of your ...

    • Titanium Recorder || Add Emerald IPC to Titanium NVR || WEB GUI

      Emerald IPC cameras come with ONVIF enabled by default. 1- Identify the camera on the network using ENSTools, login and configure a static IP address. 2-Login on the 3rt party brand in this case is a Titanium NVR, add camera and use the manual ...

    • Diamond IPC || How to Set Snapshot Function (WEB 3.0) || Web GUI

      How to Set Snapshot Function (WEB 3.0) This article provides a step-by-step guide for configuring the snapshot function on devices using the WEB 3.0 firmware. The instructions may vary slightly depending on the model and firmware version of your ...