Emerald IPC || How to enable Panoramic PTZ Linkage for EM-TPTZP44100-X25-LHAD

Emerald IPC || How to enable Panoramic PTZ Linkage for EM-TPTZP44100-X25-LHAD

How to enable Panoramic PTZ Linkage for EM-TPTZP44100-X25-LHAD

Enter setup menu

 

 

Enter Intelligent menu

 

Under Smart-> (1)Enable Panoramic Linkage and select the (2)Configuration button

 

 

 

Ensure (1)Panoramic Linkage is enabled, and select (2)Continuous Track if needed.(This will ensure that it will track as long as it is in frame) Select (3)Calibration.

 

 

 

After selecting Auto Calibrate, it will ask to complete the Manual Calibration.

 

 

It is important to (1)align the PTZ (right) to the center of the panoramic camera (Left). Finish (2)Calibration and select (3)Next.

 

 

Select One-Click Calibrate to complete the Auto Calibration. Select Finish.

 

 

Using any Perimeter Protection (Intrusion, leave area, intrusion, ETC) Under “Trigger Actions” you can enable Panoramic Linkage.

    • Related Articles

    • ENS IPC || Smart tracking for ENS PTZ camera

      ENS IPC || SPT5C425IR-E(T5) Setup PTZ Smart Tracking Access the web portal for the PTZ camera and go into VCA Within VCA Resource>enable Smart Event and click save Go into smart event and enable the smart event you want to be triggered(intrusion, ...

    • Diamond IPC || Setting Up Auto Tracking PTZ New Interface || Web GUI

      Diamond IPC || Setting Up Auto Tracking PTZ New Interface || Web GUI Begin by accessing the Web GUI of the PTZ camera and select the setting icon in the upper right of the web page. Select PTZ and adjust where you would like to set the home position ...

    • UNV IPC || PTZ Auto Tracking

      Log into the PTZ. Click on Setup Navigate to Intelligent- -> Smart --> Auto Tracking., then click on the Gear icon Enable Alarm Sound and Alarm Lights if needed under "Trigger Actions"

    • Titanium IPC || Enabling PTZ Auto Tracking

      Enabling Titanium PTZ Auto Tracking Logging into the camera directly Select Config on web page On the left hand side choose an “Event” For this example we chose “Line Crossing” Enable the event Enable “Trigger Track” Save settings In the next section ...

    • Emerald IPC || IP Camera Hard Reset

      This guide will use EM-IPCP8D3-F28-LH-AI as an example of a IPC that has a physical reset button. IPCs with a reset button will be listed at the bottom as well as a video demonstration. Step 1. Verify that the device is powered up. One of the ways ...