Emerald IPC || IP Camera Hard Reset

Emerald IPC || IP Camera Hard Reset

This guide will use EM-IPCP8D3-F28-LH-AI as an example of a IPC that has a physical reset button. IPCs with a reset button will be listed at the bottom as well as a video demonstration. 

Step 1.
Verify that the device is powered up. One of the ways you can do this is by using ENS Tools to see if the IPC is online. 
enstoolsnoother.png

Step 2.
Locate the cover on the IPC body and remove any screws that may be holding it down.
EMIPC.jpg

Step 3.
Hold down the reset button for about 10 - 15 seconds.
The IPC will reboot and the reset will be complete.
EMIPCcoveroff.jpg


Models WITH reset buttons.
EM-IPCE2B100-X10-LH-AI
EM-IPCE4B150-X22-LH-AI
EM-IPCP4B3-F40-FC-AI
EM-IPCP4B4-F28-AD-AI
EM-IPCP4B4-F28-M-LH-AI
EM-IPCP4B5-MZ-LH-AI
EM-IPCP4D4-MZ-M-LH-AI
EM-IPCP4T3-F28-FC-AI
EM-IPCP5FE1-F14
EM-IPCP8B3-F28-AD-AI
EM-IPCP8B3-F40-FC-AI
EM-PTZE26500-X33-LH
EM-PTZE28250-X45-LH
EM-PTZE48250-X40-LH
EM-PTZP26150-X25-LH
EM-PTZP46150-X33-LH
EM-PTZP5750-X4-AD
EM-PTZV26150-X25-LH
EM-PTZV44100-X25-LH
EM-PTZV4530-X5-IN




    • Related Articles

    • ENS IPC || IP Camera Reset via Button

      ENS-H || IP Camera Reset Button Most ENS-H series IP cameras come with a hard reset button. 1. Disconnect the IP camera from the power source. 2. Press and hold the reset button down then power it back up. 3. Continue to hold the reset button down ...

    • Emerald IPC || How to reset IP camera

      1. Log onto the remote web interface 2. Under the setup menu, on the left hand side go all the way down to the System tab 3. Under the system tab, go to the maintenance option and you will see config management, the default option factory defaults ...

    • Titanium IPC || IPC Password Reset ||

      Resetting IP Camera to Default Settings Using Open IP Tool Ensure Network Connection: Confirm that the computer you are using is connected to the same network as the camera. This is essential for the IP tool to communicate with the camera. Launch ...

    • Emerald IPC || How to view snapshots from IP Camera

      Log into the web interface Under the photo option on the top of the page it will take you to where the snapshots are stored on the camera. In this screenshot the camera was set to take snapshots whenever motion is detected. Navigate to the proper ...

    • Emerald IPC || How to locate IP Camera on LAN via ENS Station

      Open ENS Station and navigate to device management Here you can see the IP cameras by IP address. You can locate your specific camera by ip address, model number or Serial number. The cameras you see already are on the network so you can quickly add ...