Reyee || Access Point to Router Mode || Web Gui

When changing your Access Points (AP) working mode to Router mode you can either add the AP to a project or use the IP address of the router.

Note: In this example we add to project first then make changes

First log in or create the project that you added your AP to

Next you will select the Access Point twice to enter the page where you can monitor, make config. changes, etc. From here you can find the IP Address or simply tunnel into the device using the EWeb option

Once you are logged in you may see other devices trying to be added if you have not added them already.

Again you will select the AP until the settings come up

Select AP> More> Network > Work Mode> MAke your change from AP to Router or even Wireless Repeater

Note: This example is using AP to Router

Accept Changes and allow for the AP to reboot

Going back to the Project you created or add the AP will no longer show the Access Point

Re-add the Access Point but as a Gateway this time

In the Overview page the AP will now show and function as a Router