Adding Access Point through Mesh || Cloud GUI

To set an Access Point through Mesh Networking you will first log into your project and sure that the device is not already added to your cloud account

Next you will change the adapter settings on computer to match that of the Reyee Access points Default IP address which is 10.44.77.254

Note: In this example I have set my adapter settings to 10.44.77.100

The Access Points Web GUI will pop up

Default Password: admin

Now you will log in and get an error message that DHCP is not enabled which to that you will select Start Setup

Next you will set the Access Point as a Repeater

Select your Wifi that you will be Repeating out

Note: This example uses the WIFI SSID of Testing

Once the WIFI has connected you will get the Operation Successful message

Take your serial number and add it to your Project in the Devices> AP section

Your Access Point will now come online and you can access this device through its new IP address that is a part of the same network