Teltonika || SMS Commands and Utilities ||

Teltonika || SMS Commands and Utilities ||

Teltonika || SMS Commands and Utilities

Author: ENS Technical Support
Date: 09/17/2026
Product / Category: Teltonika

Article Description

Send commands by text message to control a Teltonika router.

Applies To

  • Models: RUT241098000, RUT956A00A00

Requirements / Before You Begin

  • Router with an SMS-capable SIM card installed
  • Phone number assigned to the SIM
  • Router WebUI login credentials

Procedure

Step 1: Enable SMS Utilities

  1. Log in to the router WebUI.
  2. Go to Services > SMS Utilities.
  3. Enable SMS Management.
  4. Set the authorization method to By device admin password (recommended for security).
  5. Set Allowed number(s) to From single number.
  6. Enter your phone number in the format +10000000000.
  7. Click Save & Apply.

Sending SMS commands

Send commands from the allowed phone number to the SIM’s number. The message format depends on the authorization method you chose:

Authorization methodMessage format
No authorization(command)
By device serial number(device serial number) (command)
By device admin password(device admin password) (command)
By password(password set) (command)

Example: password123 reboot

Step 2: Test SMS sending from the router

  1. Go to Services > Mobile Utilities > Messages > Send Messages.
  2. Enter a test phone number in the format +10000000000.
  3. Type a test message.
  4. Send the message.
  5. The phone number you entered should receive the message.

Verification

  • Sending test: The test phone receives the message from Step 2.
  • Command test: After you text a command (such as reboot), the router performs that action.

Notes / Troubleshooting

  • If the router doesn’t respond, confirm the message comes from the allowed number, the format matches the selected authorization method, and the SIM has signal and SMS service.
  • Commands are case-sensitive in some cases, so enter them exactly as listed in Teltonika’s SMS command documentation.