Titanium General || Face Detection Limited to 1 Channel After Upgrading NVR to v1.4.13 ||

Titanium General || Face Detection Limited to 1 Channel After Upgrading NVR to v1.4.13 ||

NVR Supports Only One Face Detection Channel After Upgrading to v1.4.13 (“No Resource”)

Applies to: TVT NVR firmware 1.4.13 and later, with face detection (AI by NVR) (confirm brand and models)

Symptom

After upgrading the NVR to v1.4.13, face detection (AI by NVR) works on fewer channels than before. An NVR that previously supported two face detection channels now supports only one. When you try to enable the second channel, a “No Resource” prompt appears.


Cause

Firmware 1.4.13 introduces AcuSearch, which requires Picture Comparison to be enabled in the NVR’s intelligent configuration interface.



Enabling Picture Comparison permanently uses 50% of the NVR’s AI resources, which reduces the number of face detection channels:


Face detection channels beforeChannels with Picture Comparison enabled
21
42

With the AI resources at 100%, face detection (AI by NVR) can’t be enabled on another IPC.

Solution

If the customer doesn’t need AcuSearch, disable Picture Comparison. This frees the AI resources, and the original number of face detection channels is available again.

  1. On the NVR, go to the intelligent configuration interface.
  2. Turn off Picture Comparison.
  3. Save the settings.
  4. Enable face detection (AI by NVR) on the additional channel.

For details on this feature, refer to the latest datasheet.

About AcuSearch

AcuSearch is a video search engine that quickly locates the information you need. If you don’t know the exact time and location a target appeared, but know some of its attributes, you can search by those attributes to find matching targets.