Titanium IPC || PTZ “Still Time” Setting Doesn’t Delay the Return to the Monitoring Position After Manual Control ||

Titanium IPC || PTZ “Still Time” Setting Doesn’t Delay the Return to the Monitoring Position After Manual Control ||

PTZ “Still Time” Setting Doesn’t Delay the Return to the Monitoring Position After Manual Control


Symptom

You set Still Time to 10 seconds, then operate the PTZ manually. The camera still returns to the monitoring position after 5 seconds, so it looks like Still Time isn’t working.


Cause

Still Time doesn’t control the return after manual PTZ operation. It applies only to tracked targets.


Setting or behavior
                                                                                                          What it controls
Still Time (return to monitoring position after the target becomes stationary)                        The number of seconds a tracked target must stay stationary (without disappearing) before the PTZ returns to the monitoring position
Return after manual PTZ control                        Fixed at 5 seconds by default. It isn’t affected by Still Time.


The customer assumed Still Time also applied to the delay after manual control. It doesn’t, so the camera returns after the default 5 seconds regardless of the Still Time value.


Solution

No fix is needed. This is expected behavior, not a fault.

  • To change how long the PTZ waits after a tracked target stops moving, adjust Still Time.
  • The 5-second return after manual PTZ operation is fixed by default and can’t be changed with Still Time.



Verification

To confirm Still Time works, let the camera track a target, then have the target stay stationary. The PTZ returns to the monitoring position after the configured Still Time.