Titaum IPC || PTZ Camera Can’t Log In or Activate: “TypeError: Cannot read properties of undefined (reading ‘createElement’)” ||

Titaum IPC || PTZ Camera Can’t Log In or Activate: “TypeError: Cannot read properties of undefined (reading ‘createElement’)” ||

PTZ Camera Can’t Log In or Activate: “TypeError: Cannot read properties of undefined (reading ‘createElement’)”

Applies to: Titanium PTZ cameras that support both firmware v5.0.1 and v5.1.1 (confirm models)

Symptom

After one of the following actions, the PTZ camera can’t be activated or logged in to, and the web interface shows this error:

“TypeError: Cannot read properties of undefined (reading ‘createElement’)”

  • A camera running v5.0.1 imports a v5.1.1 configuration file.
  • A camera running v5.1.1 is upgraded using v5.0.1 firmware.

Cause

The firmware and the configuration file don’t match. By design, v5.0.1 doesn’t support the activation feature, and v5.1.1 does. A v5.0.1 camera can’t use a v5.1.1 configuration file. The mismatch breaks the camera’s login and activation pages.

Solution

1. Restore the camera

Contact Technical Support to restore the camera. Once it is restored, the web interface can be logged in to again.

2. Re-upgrade in the correct order

  1. Upgrade the camera to v5.1.1 firmware.
  2. Wait for the upgrade to finish and the camera to reboot.
  3. Import the v5.1.1 configuration file.

Verification

Log in to the camera’s web interface. The login and activation pages load without the error.