Titanium General || Web Playback Error: “The decoding capacity of the plugin has reached the maximum limit (24MP)” ||

Titanium General || Web Playback Error: “The decoding capacity of the plugin has reached the maximum limit (24MP)” ||

Web Playback Error: “The decoding capacity of the plugin has reached the maximum limit (24MP)”

Applies to: TVT NVR web interface with the browser plugin installed (confirm brand

Symptom

After installing the NVR browser plugin and playing back recordings from the web page, one of these errors sometimes appears, depending on firmware version:


Cause

The plugin crashes if its memory use exceeds 4 GB during web playback. To prevent this, the plugin limits playback based on the total resolution of all streams playing at once, which is capped at 24MP.

When playback exceeds 24MP, the plugin closes the stream for that channel and returns error code 536870932 (insufficient decoding capacity).

The older message, “Lack of means to decode the image,” doesn’t mention the 24MP limit, so customers often misunderstood why the stream failed. Starting with NVR version 1.4.12.250226 (version number 77222 or higher), the message was reworded to state the limit clearly.

Both messages describe the same issue.

Solution

Reduce the total resolution being played back by doing one or more of the following:

  1. Lower the camera’s recording resolution.
  2. Select fewer channels for playback.
  3. Switch to the sub-stream for playback.

Notes

  • The limit applies to the combined resolution of all channels playing at the same time, not to each channel individually.
  • Example: a few 8MP (4K) channels can reach 24MP quickly (3 channels of 8MP = 24MP).