Why Web Backups Split Recordings into Multiple Smaller Files
Question
When backing up recordings to a specified folder from the NVR web playback interface, the backup is split into multiple files. Why?
Answer
The NVR limits the size of each backup file. The limit depends on the firmware version and the backup method, so a long recording is saved as several segments.
Maximum size per backup file
| Backup method | Firmware earlier than 1.4.12 | Firmware 1.4.12 and later |
|---|
| Web backup via Internet Explorer | 768 MB | 2 GB |
| Web backup via non-IE browser (plug-in & HTML5) | 10 MB | 1 GB |
| USB flash drive backup | 768 MB per video | 2 GB |


Why the Limit Exists
Limiting file size is standard practice across the surveillance industry, for two reasons.
1. Data reliability
Reliability is the core requirement for surveillance recordings. Smaller segments reduce the risk of data loss:
- If a power outage, storage removal, I/O error, or other fault occurs during backup, an oversized file may be completely corrupted and unrecoverable. With segmented files, only the small segment being written may be damaged, and all previously completed files remain intact.
- If bad sectors or file corruption develop on the storage media later, the damage is limited to a single small file instead of several hours of footage, which lowers recovery cost.
NVRs are embedded devices with limited CPU, memory, and I/O bandwidth:
- Handling very large files (over 1 GB) consumes a lot of resources for file system metadata and cache scheduling. This can cause dropped frames in normal recording, slow device response, or even a protective reboot.
- Writing in fixed-size segments lowers the peak I/O load and keeps backup and normal multi-stream recording stable at the same time.