Titanium General || NVR/DVR Shows a “No Disk” Pop-Up at Startup That Can’t Be Turned Off ||

Titanium General || NVR/DVR Shows a “No Disk” Pop-Up at Startup That Can’t Be Turned Off ||

NVR/DVR Shows a “No Disk” Pop-Up at Startup That Can’t Be Turned Off

Applies to: Titanium NVR firmware 1.4.5 and later, DVR firmware 1.3.8 and later (confirm models)

Symptom

When no hard drive is connected, a “No Disk” pop-up appears every time the NVR/DVR is powered on or restarted. The alert can’t be disabled and stays on screen until you click OK.



Cause

The mandatory “No Disk” alert was added in NVR 1.4.5 / DVR 1.3.8. If no disk is detected at startup or during operation, the pop-up appears.

Video recording is the main function of an NVR/DVR, and a hard drive is essential for storage. The alert stays open until the user clicks OK, which serves as a mandatory reminder to prevent recording loss from oversight.

Solution

Option 1: Install a hard drive

Connect a hard drive to the NVR/DVR. Once a disk is detected, the “No Disk” alert no longer appears.

Option 2: Turn off the pop-up (NVR 1.4.13 and later)

In NVR 1.4.13, the mandatory “No Disk” alert became a configurable option, controlled by the Pop-up Message Box setting:


  1. On the NVR, go to the setting for Pop-up Message Box.
  2. Set it to OFF.
  3. Save the settings.