Titanium General || Error 0x20000002 When Adding an IPC to a DVR ||

Titanium General || Error 0x20000002 When Adding an IPC to a DVR ||

Error 0x20000002 When Adding an IPC to a DVR

Applies to: TVT DVR and NVR, adding an IPC by IP address 

Symptom

When you add an IPC to the DVR by IP address, this error appears: “Unknown error! Error code: 0x20000002”.


Cause

The IPC has not been activated. A camera must be activated before a recorder can add it.

Solution

Activate the IPC, then add it to the DVR again. Use any one of the following methods.

Option 1: Activate with the IP Manager tool

  1. Open the IP Manager tool on a PC connected to the same network as the camera.
  2. Select the unactivated IPC from the device list.
  3. Set an activation password and complete the activation.


Option 2: Activate from the camera’s web interface

  1. Open a browser and enter the camera’s IP address.
  2. Follow the activation prompt and set a password.

Option 3: Activate from the NVR (NVR firmware 1.4.6 and later only)

NVR firmware 1.4.6 and later can activate an IPC and let you set a custom IPC activation password.