Titanium IPC || Alarm out wiring and config

Titanium IPC || Alarm out wiring and config

IP-5IR8E33/MZ-L used in example

image-1625704147173.png

Alarm Ports from IPC

1_ Alarm COM (constant power)

2_ Normally Open contact (alarm out to load)

3_ Alarm IN (from load)

4_ Ground

 

image-1625704181156.jpg

Relay wiring from IPC alarm out

1_COM = 12v+ (constant from power supply)

2_OPEN = 12v+ (to load that will be powered once alarm is triggered) 

 

image-1625704232686.jpg

Alarm Trigger (Intrusion used in example)

Log into IPC to configure.

Intrusion > enable > alarm out > save

If there is an SD card inserted into the camera,

You can set up SD Recording or snap capture as needed.

Manually triggering alarm out

    • Related Articles

    • Titanium IPC || Modify a Titanium IPC Address

      Titanium IPC cameras IP address is 192.168.226.201 by default. We have two ways to change IP on the camera: we can change IP by the IPtool or log into to the camera or configure a static IP address. 1-Change IP by IPtool: Open IPtool as administrator ...

    • Akuvox Local || A092S Electronic Lock wiring with Fire Alarm

      A092S Electronic Door Lock wiring with Fire Alarm These are instructions on how to wire in electronic locks with a Fire Alarm Trigger to provide an Unlock to all doors when there is an Active Fire Alarm. We will utilize the A092S included General ...

    • Titanium IPC || Titanium IPC Firmware Update

      Titanium Upgrade Firmware IP camera: We have three ways to update FW on IP cameras: Directly through the camera’s GUI, through the upgrade tool, or by the NVR that is running the 1.4.6+ FW version. Note: If you have a kernel update, perform the ...

    • Titanium Recorder || Add Emerald IPC to Titanium NVR || WEB GUI

      Emerald IPC cameras come with ONVIF enabled by default. 1- Identify the camera on the network using ENSTools, login and configure a static IP address. 2-Login on the 3rt party brand in this case is a Titanium NVR, add camera and use the manual ...

    • Titanium IPC || IPC RTMP Streams

      Camera will support RTMP in version 5.1.1 The introduction for the usage of RTMP on IPC Note: RTMP Protocol only can support H.264(Audio&video) IPC support from version 5.1.1(All camera series supported) Click the RTMP module in the NetWork module ...