Titanium IPC || Modify a Titanium IPC Address

Titanium IPC || Modify a Titanium IPC Address

Titanium IPC cameras IP address is 192.168.226.201 by default.

We have two ways to change IP on the camera: we can change IP by the IPtool or log into to the camera or configure a static IP address.
 

1-Change IP by IPtool:

Open IPtool as administrator select the camera, on the right side we can modify the network Parameter and manually change the IP address. In this example we’ll use 192.168.4.25
 

Make sure you have the right subnet mask 255.255.255.0 and Gateway 192.168.4.1.
 

We have to enter the default password on the tool 123456. (Please use Ens12345! If this does not take. Select modify to change to a static IP address.

 

 

2-Change IP by web client login (default IP address)

We have to identify the camera with the IPTool and log into the IPC, in case the computer is on a different network we have to add the 192.168.226.100 Network on the local network adapter to allow communication.
 

Select Network Setting, TCP/IPv4, Advanced and we can add an address that is on the same network as the IPC.

 

 

 

Login to the camera by the web browser Internet Explorer or Edge and select Network settings

 

Select TCP/IP menu and you will see the default address of 192.168.226.201

You have to change it manually and type the desired IP address ex:192.168.4.25, subnet mask 255.255.255.0 and Gateway 192.168.4.1. ones you finish you can save the changes and the camera it is going to reboot, and you can login with the IP address that you configure before.
 

In case that you want the camera addressed by DHCP, select Obtain IP address automatically. NOTE: Your camera should use a static IP address. If you do not, the DHCP lease can expire, and the address will change. This will sever the NVR-IPC communication

 

 

    • Related Articles

    • Titanium IPC || How to Set Up External IP Camera || Local GUI

      ***You will need a Windows based computer that is connected to the same physical network as the IP cameras to configure them with the necessary software*** Note: You will need to use the IP Tool (IPTool 2.0) to configure cameras that are on an ...

    • Titanium IPC || How to Set Up External IP Camera || Web Client

      To access the web client, please use a Windows based PC and use Internet Explorer as the web browser. Note: You will need to use the IP Tool (IPTool 2.0) to configure cameras that are on an external POE switch. With this tool, you will be able to ...

    • Titanium IPC || Titanium IPC Firmware Update

      Titanium Upgrade Firmware IP camera: We have three ways to update FW on IP cameras: Directly through the camera’s GUI, through the upgrade tool, or by the NVR that is running the 1.4.6+ FW version. Note: If you have a kernel update, perform the ...

    • Titanium IPC || IPC RTMP Streams

      Camera will support RTMP in version 5.1.1 The introduction for the usage of RTMP on IPC Note: RTMP Protocol only can support H.264(Audio&video) IPC support from version 5.1.1(All camera series supported) Click the RTMP module in the NetWork module ...

    • Titanium Recorder || Add Emerald IPC to Titanium NVR || WEB GUI

      Emerald IPC cameras come with ONVIF enabled by default. 1- Identify the camera on the network using ENSTools, login and configure a static IP address. 2-Login on the 3rt party brand in this case is a Titanium NVR, add camera and use the manual ...