UNV CMS + Software || How to locate IP Camera on LAN via EZ Station

UNV CMS + Software || How to locate IP Camera on LAN via EZ Station

How to locate IP Camera on LAN via EZ Station

 

  1. First you will need to connect your camera to your LAN so it can be discoverable

 

  1. Once you have done that you will need to open up EZ STATION and it should take you to the main control panel page. From there you should see on the bottom a setting called device management (red box)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  1. From there you will see devices added (green) and devices that are discovered but not added to the recorder

 

 

 

 

 

 

 

    • Related Articles

    • Emerald IPC || How to locate IP Camera on LAN via ENS Station

      Open ENS Station and navigate to device management Here you can see the IP cameras by IP address. You can locate your specific camera by ip address, model number or Serial number. The cameras you see already are on the network so you can quickly add ...

    • Emerald CMS + Software || How to add IP Camera from LAN to ENS Station

      1. Open ENS Station and go to device management 2. Identify the camera you would like to add from the online device area 3. After adding the device it should look like this 4. To locate the camera, under operations click on the gear symbol ...

    • Emerald IPC || How to locate device on LAN via ENS tool

      How to locate IP Camera on LAN via ENS Station 1.Connect camera to POE switch 2.Open ENSTools and camera should take a few moments to pop up (Highlighted below) 3. Under the configuration tab click on the E symbol corresponding to the camera and log ...

    • Emerald CMS + Software || Add device via IP

      (This demonstration was done on MacOS 12.0 Monterey) 1) First Open ENS Station and go into Device Management. 2) There are two ways of adding a system with the IP Address. We’ll first demonstrate how to add a device manually by looking under Device ...

    • Emerald CMS + Software || Add device with IP ||

      ENS Station: Add Device via IP (This demonstration was done on MacOS 12.0 Monterey) 1) First Open ENS Station and go into Device Management. 2) There are two ways of adding a system with the IP Address. We’ll first demonstrate how to add a device ...