Note: This function or management page may vary with models. Please see the actual Web interface for details.

Note: Only some certain models support third stream.

To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”.

1. Log into the web client by typing IP address on the URL and entering login credentials.

2. Once logged in click the setup tab located on top.

3. In the setup menu, click video and audio located on the left.

4. Click on the Snapshot tab on the left side.

5. Configure parameters as needed.

Note: Scheduled snapshot uses the Normal type of schedule. Event-triggered snapshot is triggered by an event such as an alarm input and a motion detection alarm. Settings effective to event-triggered snapshot also apply to manual snapshot. Note: Snapshot interval is the length of time between two snapshots.

Snapshot Interval: Interval between two snapshots. For example, with Snapshot Interval set to 1 and Number of Snapshot set to 2, the camera will take 2 snapshots (take one first and then take another after 1 second).

Number to Snapshot: Currently 1, 2 and 3 Snapshots are allowed