UNV IPC || IP Configuration using EzTools 2.0 (2.2.0)

UNV IPC || IP Configuration using EzTools 2.0 (2.2.0)

You can modify addresses in two ways using EzTools:

The "IP" button will allow you to manually program a IP address.
The "settings" button will allow you to toggle DHCP

 

image-1620811124270.png

When using the "IP" option, you must enter the New IP, Subnet Mask, and Gateway. Make sure to enter the correct username and password. The default is admin/123456

image-1620811463764.png

You will receive a confirmation that the modification was successful.

image-1620811347069.png

When using the "settings" method, you first be prompted to log into the device. Enter the credentials to the device and press OK.

image-1620811508324.png

"IP Obtain Mode" will allow to use Static, DHCP, or PPPoE addresses.
When using the "Static IP Address" option you may enter the IP address information in manually and "Save".

image-1620811632182.png

You will receive a warning prompting you that changing settings may cause network disconnection - confirm your IP address information is correct before pressing "Yes"

image-1620811800262.png