To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

After logging in, select the “Setup” option.

After Selecting Setup, select VCA.

After selecting VCA, select the Intrusion Detection sub-menu.

On the Intrusion Detection Page, select the camera that intrusion detection should be enabled on. Make sure that Intrusion Detection is set for On. Draw the intrusion perimeter and configure the detection area as needed. The primary information needed will be the sensitivity and percentage. Percentage will be the amount of the drawn area that must be filled in order to trigger the intrusion. Select Arming schedule and Trigger actions to indicate when the line cross schedule is active, as well as the commands that it will trigger (record on separate channels, audible alarms, alarm out, email notifications, etc.)