Akuvox General || How to use Akuvox Door Phones to open and close motorized doors and gates (Bi Stable) mode
How to use Akuvox Door Phones to open and close motorized doors and gates (Bi Stable) mode.
NOTE: Selected models support this mode.
This feature will allow you to change the mode of the built in relay to become an “open/closed” switch. This allows the user to press the usual “unlock” button on the smartplus mobile app to either unlock doors or open gates and keep them open permanently until the “unlock” button is pressed again.
For Door Phones that support “Bi Stable” relay modes, all you need to do is go into the relay settings and select the Relay mode to “Bi-Stable”
Related Articles
Akuvox General || Hang Up After Open Door
Akuvox General - Hang Up After Open Door ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Log into Web Portal for the Akuvox Door Phone and navigate to: Intercom ~> Call Feature ~> Hang Up After Open Door Example: (Some models will have a different navigation in ...Akuvox General || How to check for “Input Trigger” logs on Door Phones
Akuvox door phones contact Door Locks which will help you determine what method was used to trigger the relay resulting in gaining access to a property. Input Logs are only available in the devices Web User Interface. To access these logs, you will ...Akuvox Local || How to Open the Door via DTMF
How to Open the Door via DTMF DTMF feature allows users to open doors by tapping the DTMF-related Unlock button or entering the DTMF code on the indoor monitor’s keypad during a call. All Akuvox intercom devices support the door opening via DTMF. In ...Akuvox General || How to Setup Land Line Speed Dial on Door Phones
Configuring Akuvox X915, X916 model Door Phones to call a landline using the Receptionist speed dial on the home screen. For landline function, please log into your Akuvox Installer Cloud Account to enable this feature. **Prerequisite: Landline is a ...Akuvox Local || Akuvox E12W - How to unlock doors via Motion detection
Akuvox E12W - How to unlock doors via Motion detection. To setup the E12 to unlock on motion you will need to make sure that HTTP Unlock is enabled, Goto "Access Control > Relay > Open Relay via HTTP" and enable this feature then create user ...