Diamond IPC || NAS Storage Setup || Web GUI

Diamond IPC || NAS Storage Setup || Web GUI

Note: 

NFS and CIFS , both of them are network protocol. NFS runs in Linux/Unix operating system normally. CIFS runs in Windows system normally.

Dimond Camera supports NAS which is only based on NFS, so there must be on NFS server to running NFS service , otherwise cameras are impossible to send recording/images by NAS mode.

  1. Download and install Config Tool
  2. Run the Config Tool
    image-1644876804339.png
  3. The Config Tool should display your IP Camera. Click the, image-1644875945795.png icon to open Internet Explorer and access your IP Camera.
  4. Login with your username and password.

    image-1649706305136.png

  5.  Go to Setting > Storage > Destination > Path

    image-1644954660149.png

  6. Select "NAS". Click on "Save" when done.

    image-1644954830305.png

  7. Go to NAS and check off "Enable". Enter the PC's address/storage path info. Click "Save" when done.

    image-1644955338269.png

    • Related Articles

    • Diamond IPC || How to Set NAS Storage (WEB 5.0) ||

      How to Set NAS Storage (WEB 5.0) This article provides a step-by-step guide for configuring NAS (Network Attached Storage) on devices using the WEB 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of your ...

    • ENS Recorder || Synology NAS setup || Web GUI

      Synology DS112J used in examples. NAS volume must not exceed 8TB Do not share one NAS volume with multiple devices, it will lead to connection/abnormal storage Adding DS112j via NFS Mount Type Log into the web page of the DS112j. The IP address of ...

    • Diamond IPC || How to Use SMB to Save Records & Snapshots to NAS (Web 3.0) ||

      How to Use SMB to Save Records & Snapshots to NAS (Web 3.0) This knowledge base article provides instructions on configuring SMB (Server Message Block) to save records and snapshots from IP cameras to a NAS (Network-Attached Storage) device. Using ...

    • Diamond Recorder || Tripwire Setup (Web GUI)

      Diamond Series Tripwire Setup (Web GUI) 1. From the Main Menu select AI 2. Select Parameters on the left. Then select Smart Plan. Select the camera channel at the top. Select and highlight IVS (You may need to deselect any other options). Select OK ...

    • Diamond IPC || How to Set Up Local Storage (Web 5.0) ||

      How to Set Up Local Storage (Web 5.0) This article provides a step-by-step guide for configuring local storage on your IPC using the Web 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of your device. ...