Diamond IPC || Configuring Video Settings of IP Camera

Diamond IPC || Configuring Video Settings of IP Camera

Note: If your IP Camera is connected to the back of an NVR, these instructions will not apply.

 
  1. Download and install Config Tool.----> Config Tool
  2. Once installation is complete, open Config Tool
  3. Config Tool should display your IP Camera. Click the, image-1644875945795.png icon to open Internet Explorer and access your IP Camera.
    image-1644876804339.png
  4. Login with your username and password.

    image-1644877088963.png

    Click on Setting > Camera > Conditions. Then you can adjust the image setting on the right.

    Click "Save" when done.

    camera.settings.PNG

    • Related Articles

    • Diamond IPC || Set Up RTMP on a Diamond IP Camera (WEB 5.0)

      How to Set Up RTMP on an IP Camera (WEB 5.0) Real-Time Messaging Protocol (RTMP) in IP cameras is used for efficient live streaming of audio, video, and data over the internet. It provides low latency streaming for real-time viewing, ensures stable ...

    • Diamond IPC || Configure Multicast on a IPC || (Web 5.0)

      How to Configure Multicast on IPC (Web 5.0) This article provides a step-by-step guide for configuring multicast on your IPC (Internet Protocol Camera) using the Web 5.0 firmware. The instructions may vary slightly depending on the model and firmware ...

    • Diamond IPC || Playback Video / Backup Video from IP Camera's SD-Card || Web GUI

      Download and install Config Tool Run the Config Tool The Config Tool should display your IP Camera. Click the icon to open Internet Explorer and access your IP Camera. Login with your username and password. Click on "Playback" On the right hand side ...

    • Diamond IPC || Configuring Date and Time on an IP Camera || Web GUI

      Note: If your camera is connected to the back of an NVR, you do not need to set the date and time on each camera. The NVR will do that automatically. If you don't have Config Tool yet, you can follow this link: Config Tool When you open Config Tool, ...

    • Diamond IPC || Configuring IP Camera to Record to SD-Card

      Download and install ConfigTool Run the Config Tool The Config Tool should display your IP Camera. Click the, icon to open Internet Explorer and access your IP Camera. Login with your username and password. After logging in, Setting > Storage > ...