Diamond Recorder || How to configure Face Detection || Local GUI
First ensure AI is enabled. Click on "DISPLAY" on the 2nd page. Then check to see if "AI Rule" is checked off. Hit "Apply" when done.
Then go back to the main page and click on "AI"
Click on Parameters > Smart Plans. Select the channel you want to enable and then click on the human silhouette. The box will turn blue. Click on "Apply" on the bottom right hand corner when done.
Under "Parameters" , click on "Face Detection" and check off the "Enable" box. Also check off "Record Channel" and click on "Apply" when done.
Next to "Schedule", click on "Setting" and set face detection schedule. Click "OK" when done and click on "Apply" one more time.
Go to "SETTING" and select "Schedule". Here you will select the Channel and then click on "Setting".
Check off "Intelligent" and click "OK". Click on "Apply".
Repeat the process for "Snapshot". Click on "Apply" when done.
Related Articles
Diamond Recorder || Face Detection (AI by Recorder) + Face Comparison (AI by Recorder) ||
Face Detection (AI by Recorder) + Face Comparison (AI by Recorder) This article provides a detailed guide for configuring the face detection and face comparison function on your recorder. The instructions may vary slightly depending on the model and ...Diamond Recorder || Face Detection (AI by camera) + Face Comparison (AI by recorder) ||
Face Detection (AI by Camera) + Face Comparison (AI by Recorder) This article provides a detailed guide for configuring the face detection and face comparison function on your recorder. The instructions may vary slightly depending on the model and ...Diamond Recorder || How to Configure Face Comparison ||
How to Configure Face Comparison This article provides a detailed guide for configuring the face comparison function on your recorder. The instructions may vary slightly depending on the model and firmware version of your device. Enable Face ...Emerald Recorder || Intrusion Detection Configuration || Local GUI
Intrusion Detection Setup (Local GUI) In the NVR menu, select VCA 2.In the VCA menu, ensure you are on the VCA config tab located on the left and then select the camera that is needed for Intrusion detection setup. Under smart intrusion prevention ...Titanium Recorder || Configure People/Vehicle detection (1.4.4) || Web GUI
Your IPC must support the People/Vehicle Perimeter function to configure. Log into your recorder and click "Function Panel" Click on the People/Vehicle Perimeter option. Tripwire configuration Click the "Tripwire" option. Enable the function and ...