To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

After logging in, select the Smart option

After you in the Smart page, you can see VCA config. You can (1) enable cross line detection and (2) go to cross line detection setup.(3) Select camera for Crossing line Detection.(4) Select Crossing line Detection analysis on Camera or NVR.

In Crossing Line Detection Setup. You can (1) set the Alarm Sound and Light. (2) Draw the Cross Line Detection Area. (3) Set up Snapshot Object type, Sensitivity and Priority.

Also you can select Arming schedule and Trigger actions to indicate when the line cross schedule is active, as well as the commands that it will trigger (record on separate channels, audible alarms, alarm out, email notifications, etc.)