***Please Note: This process will ONLY work with ENS Series cameras***

To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

Depending on the firmware of the recorder, there may be an updated plugin available. If so, you will see the following prompt. Follow the previous instructions to update the plugin.

Once logged into the system, select the Configuration tab.

On the Configuration menu, select Event tab.

In the Event menu, select Smart Event.

On the Smart Event menu, select the camera you want to set up the Line Crossing and select the Line Crossing Detection tab. Please note that only ENS line IPC supports Line Crossing VCA will support the function.

On the Line Crossing page, you will be able to draw a line intrusion as wanted. You may determine the direction of the line as well as the Max./Min. Size of object in the scene for the detection. Make sure to enable Line Crossing Detection by marking the checkbox.

You may also modify the schedule of motion detection under “Arming Schedule” tab.

Then you may enable the optional reactions along with the line crossing triggering, such as send email, buzzer, or trigger local alarm output, under Linkage Action tab.