ENS Recorder || How to enable Virtual Host on ENS H recorders (Web GUI)
How to enable Virtual Host on ENS H recorders (Web GUI)
Note: Virtual host allows you to connect to cameras using the local IP address of the recorder. Virtual host cannot be accessed remotely across different networks.
-
Log into your recorder and locate the Configuration tab.
-
Click on Network on the left hand side, then underneath it, click on Advanced Configuration.
-
Select the Other tab near the top right corner and then click on Enable Virtual Host.
-
Click Save to apply the setting.
-
You may now click on System near the top left hand corner.
-
Select Camera Management > IP Camera to pull up the camera list.
-
From here you can now click on the link Listed under Connect.
-
You are now able to enter the camera’s web interface from your local network.
Related Articles
Titanium Recorder || Enable virtual host || Web GUI
The virtual host function allows you to access a Titanium IP camera that is connected to the built in PoE. This helps eliminate the need to wire directly to the built in PoE to gain access to a camera and change settings. The virtual host function is ...Titanium Recorder || Accessing cameras remotely through virtual host (1.4.4) || Web GUI
The virtual host port uses two ports to communicate with the IP camera. Each channel on the NVR will have two unique ports. The virtual host port will start at 591XX for HTTP, 581XX for DATA. XX= ChID. You can port forward these ports to gain remote ...ENS Recorder || Prepping Recorder for ENS Vision || Web GUI
To access the web client, please use a Windows based PC and use Internet Explorer as the web browser. Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: ...ENS Recorder || Configuring Intrusion Detection || Web GUI
***Please Note: This process will ONLY work with ENS Series cameras*** To access the web client, please use a Windows based PC and use Internet Explorer as the web browser. Access the recorder’s web interface by typing in the IP address on the ...ENS Recorder || Configuring Line Crossing || Web GUI
***Please Note: This process will ONLY work with ENS Series cameras*** To access the web client, please use a Windows based PC and use Internet Explorer as the web browser. Access the recorder’s web interface by typing in the IP address on the ...