To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

Depending on the firmware of the recorder, there may be an updated plugin available. If so, you will see the following prompt. Follow the previous instructions to update the plugin.

Then you will enter the login page. Please log in with appropriate username and password. The device will be locked after 5 failed login attempts.

After logging in the recorder Web interface, click on “Configuration” on top.

When in the configuration page, you may find the “Platform Access” tab in the Advanced Settings of Network section.

When in the Platform Access setup page, check on the “Enable” box and you will need to create a passcode for Stream Encryption or also known as Verification Code. Make sure to hit “Save” before leaving the page.

Refresh the web page to make sure the “Register Status” shows “Online”. In other words, the recorder is ready to add to the ENS Vision APP.

To finish the last step of adding the device to the APP, a couple ways to do that, including add the device through the IP address, device S/N number, or QR Code. Due to the high standard of security protection, the QR code of the recorder is ONLY available in the Local Interface. You will need to physically go to the local recorder for the QR Code, which is located at Main Menu > System > Network > Advanced > Platform Access.