Akuvox General || How to Log into Device Web Interface

Akuvox General || How to Log into Device Web Interface

How to Log into Device Web Interface

  •  

Enter the device IP address in a browser, and you can log into the device web interface for configuration, troubleshooting, and more.

  • To check the IP address of different door phones, please refer to:

Check IP Address of Akuvox Door Phones

  • To check the IP address of different indoor monitors, please refer to:

Check IP Address of Akuvox Indoor Monitors

Fill in the username and password to log in. The default is admin.

Note

See how to reset if you forget the password:

 

    • Related Articles

    • Akuvox General || Remote Maintenance for Office Device

      Remote Maintenance for Office Device You can provide users with remote maintenance in terms of device data transmission type configuration, device reboot, device web interface remote control and device provisioning, etc. for the device in the ...

    • Akuvox General || Akuvox pre-requisite and requirements

      1. An Akuvox Installer Account Web Portal Login (If planning to use cloud services to setup and manage) a. Installer accounts are created for all new Akuvox customers. This account is used to create, setup and manage each project/ property, Akuvox ...

    • Akuvox General || Akuvox A02S 12-Volt Output Configuration

      Akuvox A02S 12-Volt Output Configuration Wires from the Electrified Strike: Connect the Ground wire to GND port Connect the Normally Open wire to RELAY_NO port **** The 12V Output must be enabled on devices web interface **** Log in to the web ...

    • Akuvox General || Maglock & Exit Button Wiring

      Maglock & Exit Button Wiring Using R20K model as an example: Log in to the web interface of the device’s IP address from a web browser. Note: To find the IP address of your device, your computer must be connected to the same network. It is ...

    • Akuvox General || Utilizing 12V Output on R27

      Using a small piece of wire as a jumper, connect the 12V OUT port to COM1 port Maglock: Connect Ground wire to GND_OUT port Connect Normally Closed wire to NC1 port **** The 12V Output must be enabled on devices web interface **** Log in to the web ...