How to Configure Discovery Mode in Intercom Devices on a Closed Network (No Internet/ Behind Firewall)

Scenario:

This is a plug and play configuration mode. Akuvox devices will configure themselves automatically when you power on the devices and connect them to the network. It is a time-saving mode and it will greatly bring you convenience by reducing manual operations. This mode does not require any configurations previously by the administrator. If you enable the discovery mode, the device will automatically scan all types of the devices on the same discovery address so that you can make a call with any devices on the call list directly without any other configuration.

Enable Discovery mode:
 

On the device web interface, navigate to Network > Advanced > Connect Setting.

Operation Instruction

• All Akuvox devices support discovery mode.

Operation Procedure

1. Discovery mode is enabled by default, if someone disabled it before, you need to enable it again.

2. Edit device address, device extension and device location.

3. If Discovery mode is adopted, the device will automatically scan all types of the devices on the same discovery address, then you can find these devices on the contacts.

Tips

If multiple devices are installed in the same device address, you need to use different device extensions to distinguish devices.

Note:
 

Figure1 corresponds to all the above steps.

Figure1

TIPS: The auto-discovery feature will work only when Connect Type is None, you can factory reset the device or select none to make it work.