Diamond IPC || Doorbell Physical & Chime install

Diamond IPC || Doorbell Physical & Chime install

IMPORTANT NOTICE: Disable the power to your doorbell and door chime before beginning physical installation

1. If not already done, disconnect the wire from the existing doorbell, that goes between it and the "FRONT" terminal on the door chime (#1 below).

Disconnect the wire from the existing doorbell, that goes between it and the Power Transformer (#2 below)

DB11PhysicalInstall0.png

2. Flip over the Doorbell and connect the Wire Harness wires, included in the box, to the back of doorbell

3. From the doorbell and the door chime, twist the two wires, one from the end of the Wire Harness and one from the door chime, and connect them together with a Wire Nut or Clip (included in the box).

Repeat this for the other set of wires from the doorbell and the Power Transformer.

4. The door chime that is already installed will either be Electronic or Mechanical.

DB11PhysicalInstall3.png

Make sure the two wires are already connected to the FRONT and TRANS connections. If they are not, adjust them so they are.

DB11PhysicalInstall4.png

5. If you are using a Mechanical door chime skip to Step 7. If you are using an Electronic door chime continue from here.

 

With the Electronic door chime, you will need to add the Chime Kit (included in the box)

DB11PhysicalInstall5.png

6. Connect the wire set shown below (included in the box) to the Chime Kit with the green Terminal Block (also included in the box).

Connect the wire set in line with the doorbell, door chime, and AC Power Transformer in the configuration shown in the diagram below:

7. The doorbell will now be installed in place of your previous doorbell.

It is safe to turn the power back on to the door bell system/power transformer

DB11PhysicalInstall7.png

8. Open your mobile app and you MUST follow the instructions below to complete your Door Chime Setup.

    • Related Articles

    • Diamond IPC || Adding Doorbell (HNC2DB112-W) to DMSS

      Diamond Series: How to Set Up The Doorbell Camera (HNC2DB112-W) to DMSS APP There are two scenarios of how to install the doorbell camera to your household or business. a. Add the doorbell camera on the side of the existing doorbell button. b. To ...

    • Diamond IPC || Wifi Doorbell Setting up HNC2DB112-W

      Contents in box 1) Power with 12v power supply (1-2amp is fine) 2)If the device does not automatically power on, you will need to hold down the reset button in the back of the unit 3)Scan QR code using DMSS application, be sure not to be so close ...

    • ENS IPC || Adding Doorbell (ES-HD2) to ENS Vision

      ENS IPC || Adding Doorbell (ES-HD2) to ENS Vision Open ENS Vision and scan QR code Select Doorbell and [NDB322-W] then continue through setup wizard Setup doorbell with network onsite and let the doorbell connect Once adding is completed, enable the ...

    • Titanium IPC || How to add ED-DB2-IC-W (Doorbell) through WIFI || Web GUI

      Connecting a Doorbell to a Wireless Network Physical Connection: Use the network cable to connect the doorbell to any available Ethernet port on the wireless router or access point (AP). You'll need to attach a 12V 5A power supply if you're not ...

    • Diamond IPC || Reset button location

      Diamond IPC password resets will work one of two ways: Hold the reset button for 20 seconds or Short circuit the PCB holes shown in the photo for your camera model for 20 seconds PDN59U225H-I