Diamond IPC || Wifi Doorbell Setting up HNC2DB112-W
Contents in box
1) Power with 12v power supply (1-2amp is fine)
2)If the device does not automatically power on, you will need to hold down the reset button in the back of the unit
3)Scan QR code using DMSS application, be sure not to be so close when scanning the QR with camera,
it will not recognize the QR code until you move camera farther back. Once scanned the S/N will appear, select NEXT.
4) It will ask you to connect to DoorbellXXXXX hotspot, you MUST enable ALL permissions or it will tell you connection failed and you will not get pass the XXXXXhotspot interface.
if customer gets this message, they do NOT have all their permissions enabled for DMSS (including location, storage, etc)
5) Create password for doorbell after selecting XXXXhotspot
6) Select the WiFi you would like to connect to and enter the WiFi Password
**keep note that you CAN NOT connect this to a 5G network
You will hear the doorbell say "Succesfully connected to network"
Name your device and hit SAVE, it will ask about Time Zone, configure DST if needed
It will ask if you would like to link a chime, if there is no chime then just skip
Camera will be succesfully added after and you will need to set up Push Notifications
Check entry Push Notifications WiFi Doorbell HNC2DB112-W
Related Articles
Diamond IPC || Adding Doorbell (HNC2DB112-W) to DMSS
Diamond Series: How to Set Up The Doorbell Camera (HNC2DB112-W) to DMSS APP There are two scenarios of how to install the doorbell camera to your household or business. a. Add the doorbell camera on the side of the existing doorbell button. b. To ...Diamond IPC || How to Link the WIFI Camera (HNC3V141S-IR/28-W) to the Local WIFI Network || Web GUI
***Note: You must use Internet Explorer to view the system via web interface*** Before making the wifi camera capable of wifi connection for the IE Web interface access or NVR recording, two things are needed to be done beforehand. Note: This camera ...Titanium IPC || How to add ED-DB2-IC-W (Doorbell) through WIFI || Web GUI
Connecting a Doorbell to a Wireless Network Physical Connection: Use the network cable to connect the doorbell to any available Ethernet port on the wireless router or access point (AP). You'll need to attach a 12V 5A power supply if you're not ...ENS IPC || Adding Doorbell (ES-HD2) to ENS Vision
ENS IPC || Adding Doorbell (ES-HD2) to ENS Vision Open ENS Vision and scan QR code Select Doorbell and [NDB322-W] then continue through setup wizard Setup doorbell with network onsite and let the doorbell connect Once adding is completed, enable the ...Diamond IPC || Doorbell Physical & Chime install
IMPORTANT NOTICE: Disable the power to your doorbell and door chime before beginning physical installation 1. If not already done, disconnect the wire from the existing doorbell, that goes between it and the "FRONT" terminal on the door chime (#1 ...