Adding the flood light camera procedure to DMSS is very similar to adding the Doorbell. Remember the new out of the box Flood light camera does not have your network configuration in it. You will need to use the DMSS app and connect to the flood camera in AP (Access Point) mode then push your Wireless Access Point SSID and password information over. Once a flood light camera is online you can then access it’s video using the DMSS app.
 

Note: You may add the floodlight to a Diamond series NVR through the private protocol
 

Here is the breakdown procedure. 

1. Flood light camera physical installation. 
   1. Flood light camera can accept 100V - 240V AC. 
   2. Turn off the flood light power, and be sure to switch the circuit breaker to off position. 
   3. Remove the existing flood light 

Using Adapter plate

1. Route the power cable through the adapter plate
2. Connect the power cable using the wire nuts provided. 
3. Use electrical tape to secure the wire.
4. Connect the ground cable to the adapter plate. 
5. Attach the adapter plate to the wall using the appropriate accessories. 

Using the junction box. 

1. You can check if the adapter plate is compatible with the existing junction box. 
2. Flood light camera adapter plate is also compatible with UJB-155 Universal junction box. 
3. However you will need to attach the adapter plate to junction box using the self taping screw provided by UJB-155. 

2. Pushing the Wireless Access Point SSID and password information to Flood Light Camera. 

2.1 Login to the DMSS application.

2.2  Click on + button

2.3 Click on S/N scan

2.4 Scan the QR code on the side of the Flood camera.

2.5 You should see the device serial number.

2.6 Follow the instructions on the App and click on Next.

2.7 Press on set

2.8 Select the SSID Camera _ Flood light serial number. 

2.9 You are now connected to the flood light camera in AP mode and ready to push network information over. 

2.10 Click on I know

2.11  Enter the Flood light password you would like to use, then OK.

2.12  Select the wireless network you would like Flood light camera to connect to. In this case I use ENS_Tech.

2.13  Input the WIFI password. Please note 5G band is not supported, only 2.4G. 

2.14  Wait for awhile, you should hear the audible sound of “Successfully connected to network”.

2.15  Input device name and save. 

2.16  Configure the time zone and Daylight Saving Time information.

2.17  You should see the Flood light camera video.

End of tutorial. 

Last Page.