Diamond IPC || How to Set Up FTP Storage on an IPC (Web 5.0) ||

Diamond IPC || How to Set Up FTP Storage on an IPC (Web 5.0) ||

How to Set Up FTP Storage on an IPC (Web 5.0)

This article provides a step-by-step guide for configuring FTP storage on an IPC using the Web 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of the device.

Ensure that the device model and firmware version support FTP storage. This tutorial is based on the Web 5.0 firmware interface.


Steps to Set Up FTP Storage

Login to the Device

Access the device's web interface.
Enter your login credentials to gain access.
image.png


Navigate to Record Settings

From the homepage, select Record.
image.png



Access Storage Settings

Go to Record > Storage.
image.png



Select Recording Mode When Disk is Full

Choose the appropriate recording mode for when the disk is full:
Overwrite: Cyclically overwrite the earliest video when the disk is full.
Stop: Stop recording when the disk is full.
image.png



Select FTP Storage Method

Choose Network Storage in the Storage Method section.
Select FTP to save the recorded videos on an FTP server.
Note: You can also select SFPT from the drop-down list. SFTP is recommended to enhance network security.
image.png



Configure FTP Parameters

Server IP: Enter the IP address of the FTP server.
Port: Enter the port number of the FTP server.
Username: Enter the username to log in to the FTP server.
Password: Enter the password to log in to the FTP server.
Storage Path: Specify the destination path on the FTP server (shared by default).
Emergency Storage: Select Emergency (Local) to save files to the internal SD card if the FTP server is unavailable.
image.png



Enable and Test FTP Function

Click Enable (1).
Click Apply to save the FTP configurations (2).
Click Test to verify that the FTP function works correctly (3).
image.png                     

 

By following these steps, you can effectively set up and configure FTP storage on your IPC using the Web 5.0 firmware. This allows for efficient and secure storage of recorded videos on an FTP server.

Additional Support

For further assistance, please contact our technical support team at support@enssecurity.com or call (888) 397-1999.

    • Related Articles

    • Diamond IPC || How to Set Up Local Storage (Web 5.0) ||

      How to Set Up Local Storage (Web 5.0) This article provides a step-by-step guide for configuring local storage on your IPC using the Web 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of your device. ...

    • Diamond IPC || How to Set NAS Storage (WEB 5.0) ||

      How to Set NAS Storage (WEB 5.0) This article provides a step-by-step guide for configuring NAS (Network Attached Storage) on devices using the WEB 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of your ...

    • Diamond IPC || How to Set Up Maintenance Function (WEB 5.0) ||

      How to Set Up Maintenance Function (WEB 5.0) This article provides a step-by-step guide for configuring the maintenance function on devices using the WEB 5.0 firmware. The instructions may vary slightly depending on the model and firmware version of ...

    • Diamond IPC || NAS Storage Setup || Web GUI

      Note: NFS and CIFS , both of them are network protocol. NFS runs in Linux/Unix operating system normally. CIFS runs in Windows system normally. Dimond Camera supports NAS which is only based on NFS, so there must be on NFS server to running NFS ...

    • Diamond IPC || How to Set Face Recognition (WEB 5.0) ||

      How to Set Face Recognition (WEB 5.0) This knowledge base article provides detailed instructions on setting up the Face Recognition function for devices using the WEB 5.0 firmware. Face Recognition is essential for identifying and comparing facial ...